How To Turn Off Bluetooth On JBL Speaker

To turn off Bluetooth on your Jbl Speaker, start by pressing the power button for one second.

Then, press and hold the Bluetooth button for three seconds. The speaker will enter pairing mode and the Bluetooth light will flash.

Finally, press and hold the power button for one second to turn off the speaker.

Locate the Bluetooth button on your JBL speaker
Press and hold the Bluetooth button for 3 seconds
The Bluetooth light will start flashing blue, indicating that the speaker is in pairing mode
Once the light is flashing blue, go to your device’s Bluetooth settings and select “JBL Speaker” from the list of available devices
Your device will now be paired with the speaker and you can begin using them wirelessly!

How Do I Turn off Bluetooth on JBL Charge 4?

Assuming you would like a step-by-step guide on how to turn off Bluetooth on your JBL Charge 4 speaker:

Begin by pressing the “Bluetooth” button located on the top of the speaker.
Doing so will put the speaker into pairing mode and the Bluetooth light will begin flashing.
Once in pairing mode, open the Bluetooth settings on your device and select “JBL Charge 4” from the list of available devices.
Once your device is connected to the speaker, press and hold the “Bluetooth” button for 3 seconds to exit pairing mode.

The Bluetooth light will stop flashing and remain solid once paired successfully.

How Do I Turn off Bluetooth on JBL Xtreme?

Assuming you would like a step-by-step guide on how to turn off Bluetooth on your JBL Xtreme speaker:

Locate the power button on the top of the speaker and press and hold it until you see the LED light next to the power button flash red.
Once it flashes red, release the power button and then press and hold it again until you see the LED light next to the power button turn solid red.

This means that Bluetooth has been successfully turned off.

Where is the Bluetooth Button on My Jbl Speaker?

If you’re looking for the Bluetooth button on your JBL speaker, it’s likely located on the top or side of the speaker. On some models, the button may be recessed into the speaker surface. If you can’t find the button, consult your speaker’s manual for more information.

Once you’ve found the Bluetooth button, press and hold it until you see a blue light flashing on the speaker. This indicates that the speaker is in pairing mode and ready to be connected to a Bluetooth-enabled device.

How Do I Put My Jbl in Bluetooth Mode?

If you’re looking to put your JBL speaker into Bluetooth mode, there are just a few simple steps you need to follow.

First, make sure that your speaker is powered on and in close proximity to your device. Then, open up the Bluetooth settings on your device and look for “JBL” in the list of available devices.

Once you select JBL from the list, it should connect automatically and you’ll be ready to start streaming music wirelessly from your device!

JBL Charge 4 Turn off Bluetooth

If you’re not using your JBL Charge 4 Bluetooth speaker, you may want to turn off the Bluetooth connection to conserve battery power.

Here’s how:

Press and hold the Power button for about 3 seconds to turn on/off the speaker.
While the speaker is turned on, press and hold the Bluetooth button for about 5 seconds until you hear a voice prompt telling you that “Bluetooth is ready to pair”.
To turn off Bluetooth, press and hold the Bluetooth button again for about 5 seconds until you hear a voice prompt telling you that “Bluetooth is disabled”.

Conclusion

If you’re not using your JBL speaker and want to conserve battery power, you can turn off the Bluetooth connection.